Operation - PROEL PLLED135 User Manual

OPERATION

After you connected the effect to the mains, the fixture starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
Each projector occupies 9 channels. To ensure that the control signals are properly directed to each
projector, the projector requires addressing. This is to be done for every single projector by changing
the DIP switches as set out in this table.
Dipswitch 1-10:
code 1=1
code 2=2
code 3=4
code 4=8
code 5=16
code 6=32
code 7=64
code 8=128
code 9=256
Please make sure that you don't have any overlapping channels in order to control each projector
correctly and independently from any other fixture on the DMX data link. If two, three or more projector
is addressed similarly, they will work similarly.
After having addressed all projectors, you may now start operating these via your lighting controller.
NOTE:
After switching on, the projector will automatically detect whether DMX 512 data is received or not. If
there is no data received at the DMX-input, this situation can occur if:
the 3 PIN XLR plug is not connected with the input of the projector
-
the controller is switched off or defective
-
the cable or connector is defective
-
the signal wires are swap in the input connector
-
WORKING MODE
Dip No.
10+8
10+8+1
10+8+2
10+8+3
10+8+4
10+7
10+7+1
10+7+2
10+7+3
10+7+4
Function
Automatic mode 5
Automatic mode 1
Automatic mode 2
Automatic mode 3
Automatic mode 4
Music mode 5
Music mode 1
Music mode 2
Music mode 3
Music mode 4
12