Display - Tascam CD-RW901SL Owner's Manual

2 − Features of the CD-RW901SL
IMPORTANT SAFETY PRECAUTIONS
DIGITAL IN/OUT (AES/EBU)
c
tors accept and output digital audio in standard profes-
sional format.
ANALOG INPUT (BALANCED) (L, R)
v
connectors accept analog audio signals at +4 dBu from
suitably-equipped units.
The wirings are: 1=grounding, 2=hot, 3=cold.
ATT control right and left
bm
screwdriver with these attenuators to reduce the output
level from either the right or left balanced analog
output. The adjustable level is up to -10 dB.
ANALOG OUT (BALANCED) (L, R)
n
connectors output analog audio signals at +4 dBu to
suitably-equipped units.
The wirings are: 1=grounding, 2=hot, 3=cold.

Display

@
R
T
DF G
This display shows various types of operation information,
including CD disc information, deck operation modes, and
menu status.
TOC The TOC indicator lights up red when a loaded disc
@
TOC
contains (Table of Contents) data.
Track number display
#
the track number is displayed.
When Incremental playback is on, and when in play-
back or playback ready mode, the
The indicator lights when a MP3 disc is in
MP3 MP3
$
the deck.
Counter display Depending on the time display mode,
%
TOTAL or REMAIN are lit. The counter display indication
are in minutes (three digits) and seconds (two digits).
The indicator lights when Key Control is on.
KEY KEY
^
PITCH The PITCH indicator lights when Pitch Control is on.
&
A.CUE The A.CUE indicator lights when Auto Cue is on.
*
The indicator lights when Auto
A.READY A.READY
(
Ready is on.
1 1
TASCAM CD-RW901SL TASCAM CD-RW901SL
These two XLR connec-
These XLR
Use a small Phillips
These XLR
# $ % ^ &
During playback or selection,
TRACK indicator blinks.
,
CONTROL I/O (RS-232C) terminal
ble serial control from an external PC can be performed.
.
CONTROL I/O (parallel) terminal
D-sub connector to connect the unit to suitably-
equipped units, allowing control of the CD-RW901SL.
The pinouts of this connector are described (see
Connections" on page 9).
/
REMOTE IN terminal
RC-RW901SL remote control unit.
!
AC IN jack Connects the power cable supplied.
* ( ) Q
H JK
A. TRACK The A.TRACK
)
Track is on.
This displays the playback level, as well as the
Meter
Q
input level of the source device.
A-B The A-B indicator lights when the A-B repeat func-
W
tion is on.
Also, this flashes until a "B-point" is entered.
REPEAT The REPEAT
E
function is on.
The indicator lights up when SYNC is on.
SYNC SYNC
R
When the SRC function is on, this lights during
REC
T
recording, or in recording standby mode.
When the SRC function is off, this flashes during
recording, or in recording standby mode.
The
OPTICAL OPTICAL
Y
source is set to optical.
COAXIAL The COAXIAL
U
source is set to coaxial.
RS-232C compati-
Use this 15-pin
Connects the supplied
W E
Y
U
I
O
P
A
S
indicator lights when the Auto
indicator lights when the Repeat
indicator lights when the input
indicator lights when the input