Pioneer DJM-2000 Operating Instructions Manual page 18

Operating an external MIDI sequencer
This unit sends the tempo of the currently playing source (BPM information)
as the MIDI timing clock. This can be used to synchronize an external MIDI
sequencer with the tempo of the source.
! External MIDI sequencers not supporting MIDI timing clocks cannot be
synchronized.
! External MIDI sequencers cannot be synchronized for sources for which the
BPM cannot be measured stably.
! MIDI timing clocks are output even for BPM values input manually by tapping
the [TAP] button with a finger. The MIDI timing clock output range is 40 BPM
to 250 BPM.
1 Connect the [MIDI OUT] terminal to the external MIDI
sequencer's MIDI IN terminal using a commercially available MIDI
cable.
2 Set the external MIDI sequencer's sync mode to Slave.
3 Press [START/ STOP].
The MIDI start message is sent.
4 Press [ON/ OFF] in the [MIDI] section.
Transmission of the MIDI messages begin.
18
En