911 turbo
Engine, Crankcase, Suspension
3. Undo the 4 fastening nuts and separate the
gearbox from the engine. Undo the upper
fastening nut on the starter motor with
Special Tool P 119.
Engine/gearbox
assembly,
separating
and joining
Separating:
1. Disconnect cables from starter motor and
reversing light switch.
Joining
2. Undo hexagon head bolt. Remove bracket
and sealing cap. Pullout the clutch release
shaft with hexagon head bolt M 6 x 40.
Note
Lubricate all sliding surfaces of the clutch me-
chanism and the splines of the drive shaft with
Olista Longtime 3 EP.
1. Guide the clutch release fork into the
release bearing and secure in the installation
position provisionally with suitable adhesive
tape.
86/868
86/869
2. Join the gearbox to the engine.
'0
3. Guide the clutch release shaft with seals into
the release fork.
4. Remove the tape through the assembly
opening.
5. Install needle bearing, sealing cap and
bracket and secure with a fastening screw
(M 6x 16).
8
10-14