Table of Contents
Advertisement
Engine,
Crankcase
DETACHING
AND
ATTACHING
ENGINE/TRANSMISSION
UNIT
(FROM
1978
MODELS,
TURBO
3.3)
Detaching
2. Place hub of release bearing upright and enga-
ge release fork on hub when attaching. Check
proper position through opening in transmission
case.
1. Disconnect wires from starter and backup
light switch.
2. Remove clutch release spring. see page
30 -11.
3. Unscrew engine mounting bolt and nuts.
3. Install clutch release spring. see page 30-11.
4. Tighten engine mounting bolt and nuts to
45 Nm (4.5 mkp).
Attaching
Note the following points.
1. Coat all sliding surfaces of clutch release as
well as spline of drive shaft with MoS2 multi-
purpose grease.
Printed in Germany
Ill. 1978 -
Detaching and Attaching Engine/Transmission Unit
10 -8
Hide quick links:
Advertisement
Table of Contents
