IBM 8852 - BladeCenter H Rack-mountable Service Manual page 54

Installing a fan pack
To install a fan pack on a 2900W power module, complete the following steps.
1. Make sure that the handle is rotated down so that it is parallel with the bottom
2. Slide the fan pack into position on the power module until it stops and locks
3. Rotate the power module handle to the open position.
4. Install the power module (see "Installing a power module" on page 37).
40
BladeCenter H Type 8852, 7989, and 1886: Problem Determination and Service Guide
Release tabs
of the module, with the power module rear connector facing up.
into place.
Handle