Installing The Shuttle - IBM 8852 - BladeCenter H Rack-mountable Service Manual

Installing the shuttle

To install the shuttle, complete the following steps.
52
BladeCenter H Type 8852, 7989, and 1886: Problem Determination and Service Guide
Shuttle
Captive thumb
screws
1. If you are installing a new shuttle, install the midplane from the removed
shuttle (see "Installing the midplane" on page 57).
2. Make sure that the release handles on the shuttle are in the open position.
3. Align the shuttle with the BladeCenter chassis and push the shuttle into the
chassis until it stops.
4. Push the release handles to the closed position. The shuttle will move back
fully into the BladeCenter chassis.
5. Tighten the captive thumbscrews on the release handles.
6. Install the upper and lower shipping brackets on the rear of the BladeCenter
unit and the rack, if they were removed (see the Rack Installation Instructions
for more information).
7. Install the two shipping screws in each side of the chassis, if they were
removed.
8. Install any of the following modules that were removed from the rear of the
BladeCenter unit:
v I/O modules (see "Removing an I/O module" on page 44).
v Management modules (see "Installing a management module" on page 47).
v Blower modules (see "Installing a blower module" on page 49).
Shipping screws
Release latch
Release handle
(open)