Zenith 32LC2DA Installation And Operating Manual page 59

Reference
Programmin the Remote
i_ The remote control is a multi-brand or universal remote control It can be programmed to operate most
remote-controHabte devices of other manufacturers.
Note that the remote control may not control all models of other brands
Test your remote control
To find out whether your remote control can operate the component
without programming, turn on the component such as a VCR and press
the corresponding MODE button (VCR) on the remote control, while
i_luminating on the selected component Test the POWER button to see
if the component responds properly. If not, the remote requires pro-
gramming to operate the device.
2
Turn on the component to be programmed, then press the correspond-
ing MODE button on the remote control.
3
Press the MENU and MUTE buttons simultaneously for 2 seconds, the
button selected component lights on the remote control If you don't
press any button for 20 seconds, the button set.ted component will turn
off on the remote control. At a moment, you have to repeat from step 2
4
Enter a code number using the number buttons on the remote. When
pressing the button, the light is blinked at a time. Programming code
numbers for the corresponding component can be found on the follow-
ing pages. Again, if the code is correct, the device will turn off.
5 .Press the MENU button to store the code. After blinking twice, this code
_s stored
6
Test the remote control functions to see if the component responds
properly. If not, repeat from step 2.
59