Battery Installation And Charging - AT&T CL84100 User Manual

Getting started

Battery installation and charging

Install the cordless handset battery as shown below.
the battery, the screen indicates the battery status (see table below). If
necessary, place the handset in the handset charger to charge the battery.
For best performance, keep the handset in the handset charger when not in
use. The battery is fully charged after 16 hours of continuous charging.
the table on page 91 for battery operating times.
If the screen shows Place in charger and
handset without interruption
enough charge to use the telephone for a short time.
summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank or
shows Place in charger and
(flashing).
The screen shows
Low battery and (flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated.
for at least 30 minutes to give the handset
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
7
Once you have installed
flashes, you need to charge the
The following table
Action
Charge without interruption until
the screen shows Low battery or
HANDSET X (at least 30 minutes).
Charge without interruption until
the screen shows HANDSET X
(at least 30 minutes).
To keep the battery charged,
place it in the handset charger
when not in use.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
See