Table of Contents
Advertisement
ProdUcT
idenTiFicaTion
Log Set
Base
Assembly Front
Burner
Figure 1 - Log Base Assembly
Top Louver
Assembly
Fireplace
Hood
Screen
Assembly
Bottom Louver
Assembly
Figure 2 - Fireplace
UnPackinG
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut the carton all the way
around above the staples on the bottom tray.
Lift the carton off the heater. Remove packing.
Note: The hood is located in the packing on
the right hand side of the heater front. Lift the
heater off the bottom tray.
119303-01A
2. Locate two screws above top corners of the
Rear
Burner
3. Remove protective packaging applied to logs,
4. Remove fireplace hood from carton insert.
5. Check all items for any shipping damage. If
OPERATION
This vent-free fireplace is clean burning. It requires
no outside venting. There is no heat loss out a vent
or up a chimney. Heat is generated by both realistic
Top Outer
flames and glowing embers. When used without the
Casing
blower, the fireplace requires no electricity making
it ideal for emergency backup heat.
SAFETY DEvICE
This fireplace has a pilot with an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS/
pilot is a required feature for vent-free room heat-
ers. The ODS/pilot system shuts off the fireplace
if there is not enough fresh air.
PIEzO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system
requires no matches, batteries or other sources to
light fireplace.
BLOWER ASSEMBLY
This fireplace has a blower assembly. The blower
operates thermostatically and has a variable
speed control. The blower circulates heated air
Blower
from the fireplace into the room. Use of blower
Assembly
is optional.
THERMOASTAT CONTROL
This fireplace has a thermostat sensing bulb and
control valve. The thermostat controls the heat
output and flame height. This maintains a consis-
tent room temperature. Even the lowest setting
provides realistic flames and glowing embers from
two burners. Selecting higher comfort settings al-
lows fireplace to run longer, producing greater heat
output. At lower comfort settings, the fireplace will
run less. This results in increased heating comfort.
This can also result in lower gas results.
www.desatech.com
fireplace screen. Remove and discard these
screws. Lift fireplace screen up and pull out
to remove.
log base assembly, and fireplace.
damaged, promptly inform dealer where you
bought fireplace.
ProdUcT FeaTUres
5
Advertisement
Table of Contents
