Table of Contents
Advertisement
insTallaTion
Continued
PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure 21,
page 15).
2. Open main gas valve located on or near gas
meter for natural gas or open propane/LP
supply tank valve.
3. Make sure control knob of fireplace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas control valve (see Figures 22 or 23).
Apply noncorrosive leak detection fluid to all
joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light fireplace (see Operating Fireplace, page
17. Check all other internal joints for leaks.
7. Turn off fireplace (see To Turn Off Gas to
Appliance, page 18, depending on your
model).
Equipment Shutoff Valve
Gas Control Valve
Figure 22 - Checking Gas Joints for
Natural Gas
Equipment Shutoff Valve
Gas Control Valve
Figure 23 - Checking Gas Joints for
Propane/LP Gas
16
INSTALLING LOGS
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
the data plates attached to the
heater base assembly. The data
plates contain important safety
and warranty information.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place bottom log in center of the base assem-
2. Rest rear log in back corner sections of base
3. Position front right log against right side of
Gas Meter
4. Position front left log against left side of grate
5. Place middle right log over front right and
6. Place middle left log over front left and bot-
Propane/LP
Supply Tank
Grate
Prongs
www.desatech.com
WARNING: Failure to posi-
CAUTION: Do not remove
bly as shown in Figure 24.
assembly as shown in Figure 24. Make sure log
is completely vertical and not leaning in toward
burner where the flame will touch the log.
grate prongs (see Figure 24).
prongs (see Figure 24).
bottom logs as shown in Figure 25, page 17.
Be sure hole in middle right log seats over pin
in bottom log.
tom logs as show in Figure 25. Be sure hole in
middle left log seats over pin in front left log.
Front
Left Log
Base
Assembly
Figure 24 - Installing Bottom Logs
Rear Log
Bottom
Log
Front Right
Log
119303-01A
Advertisement
Table of Contents
