Related Manuals for Dini Argeo DGT1SAN
Summarization of Contents
Firmware and Setup Mode
Check Firmware Version
Instructions on how to verify the device's firmware version for compatibility.
Key Function in Setup Mode
Overview of the main buttons and their functions within the setup menu.
Configuration Menu Overview
Lists the primary menu options for configuring the weight transmitter.
Scale Configuration and Calibration
Maximum Scale Capacity and Increment Setting
Guides users on setting the maximum measurement capacity and the smallest detectable weight increment.
Theoretical Calibration Procedure
Step-by-step procedure for performing a theoretical calibration of the scale.
Dead Load Zeroing (Pre-Tare Zeroing)
Explains how to perform zeroing for the scale's structure or tare weight.
Zero Adjustment
Details the process for adjusting the zero point of the scale.
Span Adjustment and Diagnostics
Span Adjustment with Sample Weight
Instructions for calibrating the scale's span using a known weight.
Load Cell mV/V Diagnostic
How to check the load cell's signal strength (mV/V) for diagnostics.
Analog Output Adjustment Procedure
Detailed steps to fine-tune the analog output voltage or current.
Input and Output Settings
Digital Input Configuration
Guide to configuring the digital inputs for various functions.
Setpoint Programming for Outputs
Steps to program specific threshold values for the digital outputs.
Communication Ports and Error Handling
Fieldbus Setting
Information on configuring the device for fieldbus communication.
RS485 Port Configuration
How to configure the RS485 serial communication port settings.
RS232 Service Configuration
Details on using the RS232 port for service and configuration.
Programming Error Solutions
A list of common error messages and their corresponding solutions.
Modbus Protocol - Holding Registers
Modbus Holding Registers (Read/Write)
Details Modbus holding registers for reading and writing device parameters.
Modbus Communication Examples
Illustrates practical examples of Modbus commands for common operations.
Need help?
Do you have a question about the DGT1SAN and is the answer not in the manual?
Questions and answers