Advertisement
Quick Links
Advertisement
Related Manuals for Dash 21.2
Summarization of Contents
Get Started
Remove Pull Tab
Initial step to prepare the remote by removing the pull tab.
Select Setup Path
Choose the correct setup based on TV location (TV1 or TV2).
Set Up Remote for TV1
Remove Battery Cover
Remove the battery cover on the back of your remote control.
Insert Key
Pull out the key, turn it over, and reinsert it showing number 1.
Adjust Signal Switch
Move the signal switch from UHF to IR using a pen tip.
Replace Cover and Continue
Replace battery cover and proceed to remote pairing.
Pair Remote to Receiver
Press SYSTEM INFO
Press SYSTEM INFO on your receiver to start pairing.
Press SAT Button
Press the SAT button on the remote to initiate pairing.
Press RECORD
Press the RECORD button on the remote as part of pairing.
Select DONE
Confirm pairing completion by selecting DONE on screen.
Program Remote to TV
Hold Device Button
Press and hold device button until all four lights illuminate.
Enter Device Code
Enter the three-digit device code while device buttons are lit.
Press # Button
Press the '#' button after entering the device code.
Power Device On/Off
Press the device power button to turn your device on or off.
Regulatory Information
Safety Instructions
Guidelines for safe operation and handling of the remote control.
Case and Use
Recommendations for cleaning, usage, and storage of the remote.
Need help?
Do you have a question about the 21.2 and is the answer not in the manual?
Questions and answers