Removal and Replacement Procedures
7. Position the docking station with the left side toward you.
✎
Make sure the docking stand and pivot arm are supported
before removing the following screws. The docking stand and
pivot arm can fall if not supported.
8. Remove the following screws:
Two PM2.5×8.0 screws that secure the cable bracket to the
1
2
Three PM2.5×8.0 screws that secure the pivot arm hinge
3
9. Remove the docking stand and pivot arm
Removing the Docking Stand and Pivot Arm
5–42
bottom case.
One PM2.5×11.0 screw that secures the pivot arm hinge
to the bottom case.
to the bottom case.
4
.
Maintenance and Service Guide