Beep Sequences During System Boot; Scsi Termination; Beep Sequences - Intel SRCU42L - RAID Controller Hardware Installation And User's Manual

2.2.2.2 Silencing the Audible Alarm in StorCon+
In StorCon+, in the Physical Configuration view, right click on the icon of the controller
requiring alarm deactivation. Click Silence to deactivate alarm. If the alarm has not been
activated, the Silence option will be grayed out.
2.2.3

Beep Sequences During System Boot

During system POST, the audible alarm on the controller will produce one of a number of
beep sequences to indicate the status of the controller. See
these beep sequences.
Table 2-3. Beep Sequences
Beep Sequence
beep - pause - beep,
beep, beep
beep, beep, beep, beep,
....
beep, beep - pause -
beep, beep - pause - ....
2.3

SCSI Termination

Termination is a commonly overlooked requirement when connecting SCSI devices
together. When these devices are connected together, the resulting set of devices is
typically referred to as a SCSI bus. SCSI devices such as hard disks and tape drives must
be terminated if they are the last physical devices at either end of the SCSI bus (if nothing
else is actively terminating the end of the bus such as a terminator or backplane). If a
device is inserted into the middle of the SCSI bus, then it (the device itself) should not be
terminated. Only terminate each end of the bus. See
(J1) SCSI bus termination settings.
Hardware Installation and User's Guide
Status
Controller startup was successful.
RAID controller has a problem. A possible cause is disk failure. To
diagnose the problem, run the Storage Console to check the status of
the RAID controller and array.
Memory or firmware may have a problem. More details may be
available from the boot message. If necessary, recover the firmware by
following the procedure in
Hardware Installation
Table 2-3 for a description of
Appendix A, "Flash Memory
Table 2-1 for a list of jumper block
Programming".
19