Table of Contents
Advertisement
Figure 2-2. Installing the IIR Controller into a Computer System
2.1.3
Changing Jumper Settings
The IIR controller normally comes ready to be installed into the computer motherboard
immediately. However, jumper settings are available to:
•
Reprogram the RAID firmware that is located in the flash memory of the IIR controller.
•
Change the configuration for SCSI power and/or termination.
The board contains 3 jumper blocks to control the functions described in
Figure 2-3 for jumper locations and pin numbers, and see
description of jumper J4.
Hardware Installation and User's Guide
PCI
Hardware Installation
Table
2-1. See
Appendix A
for a detailed
15
Advertisement
Table of Contents
