Redundancy And Error Handling - Intel RS2BL080 - RAID Controller Hardware User's Manual

Redundancy and Error Handling

•
In-band and out-of-band SES2.
•
Enclosure management support.
•
Support the internal SAS Sideband signal SFF-8485 (SGPIO) interface.
•
Drive coercion (auto-resizing to match existing disks).
•
Auto-detection of failed drives with transparent rebuild. There must be disk activity
(I/O to the drive) for a missing drive to be marked as failed.
•
Auto-resume on reboot of initialization or rebuild (must be enabled before virtual
disk creation).
•
Smart initialization automatically checks consistency of virtual disks if there are five
or more disks in a RAID 5 array, which optimizes performance by enabling read-
modify-write mode. RAID 5 arrays of only three or four drives use Peer Read mode.
•
Dirty cache LED plus error reporting for cache write to disk.
•
Smart Technology predicts failures of drives and electronic components.
•
Patrol Read checks drives and maps bad sectors.
•
Commands are retried at least four times.
•
Firmware provides best effort to recognize an error and recover if possible.
•
Failures are logged from controller and drive firmware, and SMART monitor.
•
Failures are logged in NVRAM, viewable from OS Event Log, Intel
Console 2; CIM, LEDs, and via alarm.
•
Multiple cache options allow configuration-specific performance optimization:
— Write-back: Faster because it does not wait for the disk but data will be lost if
— Write-through: Usually slower but ensures data is on the disk.
— Read Ahead: Predicts next read will be sequential and buffers this data into the
— Non-Read Ahead: Always reads from the drive after determining exact location
— Adaptive Read Ahead: Reads ahead and caches data only if doing sequential
— I/O setting: Determines whether read operations check the cache before reading
•
Redundancy through:
— Configuration stored in non-volatile RAM and on the drives (COD).
— Hot-swap support.
4
power is lost.
cache.
of each read.
reads.
from disks.
✧ Cache I/O: Checks cache first; only reads disk if data is not in the cache.
✧ Direct I/O: Reads data directly from disk (not cache).
Intel® RAID Controller RS2BL080 Hardware User's Guide
®
RAID Web