Table of Contents
Advertisement
Fireplace inSTallaTion
SELECTING LOCATION
To determine the safest and most efficient location
for the fireplace, you must take into consideration
the following guidelines:
1. The location must allow for proper clearances
(see Figures 1 and 2).
2. Consider a location where the fireplace will
not be affected by drafts, air conditioning
ducts, windows or doors.
3. A location that avoids the cutting of joists or
roof rafters will make installation easier.
4. An outside air kit is available with this fireplace
(see Optional Outside Air Kit on page 6).
MINIMUM CLEARANCE TO
COMBUSTIBLES
Back and sides of fireplace
Front of fireplace
Floor**
Perpendicular wall to opening
Top spacers
Mantel clearance
Chimney outer pipe surface
* Not required at nailing flanges
** See step 2 of Framing
WARNING: Do not pack re-
quired air spaces with insulation
or other materials.
Minimum/Maximum Chimney Height
The minimum height of the chimney, measured
from the base of the fireplace to the flue gas outlet
of the termination, is 16 feet for straight flue or a
flue with one elbow set. The maximum distance be-
tween elbows is 6 feet. For systems with two elbow
sets, the minimum height is 22 feet. The maximum
height of any system is 50 feet. This measurement
includes the fireplace, chimney sections and the
height of the termination assembly at the level of
the flue gas outlet (see Figure 15, page 9).
FRAMING
1. Frame the opening for the fireplace using the
dimensions shown in Figures 1 and 2.
2. If the fireplace is to be installed directly on
carpeting, tile (other than ceramic) or any
combustible material other than wood floor-
ing, the fireplace must be installed upon a
metal or wood panel extending the full width
109493-01K
1
/
" min.*
1
2
48" min.
0" min.
12" min.
0" min.
see Mantels, page 5
2" min.
www.desatech.com
and depth of the fireplace.
3. Set the fireplace directly in front of this open-
ing and slide the unit back until the nailing
flanges touch the side framing.
4. Check the level of the fireplace and shim with
sheet metal if necessary.
5. Before securing fireplace to prepared framing,
the ember protector (provided) must be placed
between the hearth extension (not supplied)
and under the bottom front edge of the fire-
place to protect against glowing embers falling
through. If the fireplace is to be installed on
a raised platform, a Z-type ember protector
(not supplied) must be fabricated to fit your
required platform height. The ember protector
should extend under the fireplace a minimum
of 1
/
". The ember protector should be made
1
2
of galvanized sheet metal (28 gauge minimum
to prevent corrosion.
6. Using screws or nails, secure the fireplace to
the framing through flanges located on the
sides of the fireplace.
51.25" (42")
59.25" (50")
Figure 1 - Framing Dimensions
65" (42" Models)
71" (50" Models)
92" (42" Models)
100" (50" Models)
Figure 2 - Corner Installation
67.125"
58.125"
30.125"
Maintain 1
/
"
1
2
Clearance at Sides
and Back of Fireplace
1
/
" Clearance
1
2
Not Required at
Nailing Flanges
5
Hide quick links:
Advertisement
Table of Contents
