Advertisement
Figure 5 - Installing Heat Reflector Strip
IMPORTANT: Make sure heat reflector strip is flush against
header and spacers are on bottom side. Heat strip should
NOT be flush with leg side but should have 1" clearance on
both ends.
Assembly
Blocks
1
1
/
"
4
Screws
Figure 6 - Installing mantel top
IMPORTANT: Align mantel top left to right before installing.
Back corner of mantel leg must be flush with edge of mantel
top before installation.
IMPORTANT: If installing a gas fireplace, vertical support
will be installed to mantel assembly after gas fireplace has
been installed. If installing electric fireplace, first install verti-
cal support and install fireplace from front of mantel. Do not
put any weight on mantel top until vertical support has been
installed.
123755-01A
Fireplace Installation
1
1
/
" Screw
4
1. Fireplace should be fully assembled. See Assembling
Header #4
2. Mantel must be installed flush with two walls. Remove
Heat Reflector
3. Place mantel base close to installation location. See fire-
Strip #8
4. If installing gas fireplace, install gas line. See Connecting
5. Position fireplace inside mantel through back opening
Mantel Top
Assembly
6. Gas fireplace with louver door: Lower bottom louver
Assembly
Blocks
Corner
of Mantel
Legs Must
be Flush
with Edge
of Mantel
Top
Mantel
Legs Flush
with Mantel
Base
www.desatech.com
Fireplace in fireplace owner's manual.
baseboard along walls where mantel is to be installed.
Baseboard will prevent proper installation of mantel and
base.
place owner's manual for installation clearances. Leave
enough room to insert fireplace from back of mantel.
to Gas Supply in fireplace owner's manual. Remember to
leave access to gas shutoff valve somewhere on mantel
base or where it is accessible to user. Check for leaks.
See Checking Gas Connections in fireplace owner's
manual.
(see Figure 7). Carefully position gas lines if applicable.
IMPORTANT: Use caution when positioning fireplace on
base. Base may scratch easily. Make sure fireplace is in
proper position within mantel opening before continuing
with installation.
door. Use two screws provided in fireplace hardware kit
and attach fireplace to wooden base. Close louver door.
Gas fireplace with fixed louver: Before installing logs
or burner assembly (see owner's manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware kit and attach fireplace base to wooden base.
Reinstall floor with screws removed previously.
Figure 7 - Installing Gas Fireplace
3
Advertisement
