Fireplace Installation - Desa P324E Owner's Operation And Installation Manual

WALL SWITCH INSTALLATION
The installation of a wall switch allows you
to activate the gas control valve and turn the
fireplace on and off. The wall switch is to be
connected. to. the. incoming. 10. volt. regular.
household wiring that supplies the electricity
to the fireplace. Refer to Wiring Diagram,
page.1.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless hand-held
remote control, wall switch must be in ON
position to be operational. The remote control
then becomes the switching mechanism for
fireplace operation.
1. Remove front refractory access panel by
lifting up and angling out of firebox open-
ing (see Figure 12).
2. WRC model receiver does not require a
battery. Receiver can be installed by first
plugging short extension cord into fireplace
receptacle..Plug.receiver.unit.into.exten-
sion cord. Finally, plug ignition module plug
into receiver unit (see Figure 13).
3. Activate remote handset battery by re-
moving insulating tab on back of handset
(see Figure 14). Battery is included pre-
installed.
4. Once battery is activated, unit is ready to
use.
5. Replace front refractory access panel.
Figure 12 - Removing Front Refractory
Access Panel (P325E/VP325E Model
Shown)
108794-01F

FIrePlACe INstAllAtIoN

www.desatech.com
Fireplace.
Receptacle
Extension
Cord
Figure 13 - Installing the WRC Remote
Receiver
Figure 14 - Installing Battery into Back of
Handset
Remote.
Control.
Receiver
Ignition.Module.
Plug
Battery Cover
12 Volt Battery
Back of
Handset
Pull.to.Remove.
Insulation Tab
11