Changing Object Display Order - Adobe CAPTIVATE 2-USING CAPTIVATE Use Manual

To align an object to the start of a slide:
•
Click an object on the Timeline and drag it to the left side of the Timeline.
To extend the playing time of an object to the end of a slide:
•
Right-click an object on the Timeline and select Show for rest of slide.
To align an object to a point in time:
•
Click an object on the Timeline and drag it to the left or right so that the left edge of the object
bar aligns with the correct time in the header.
For example, if you have a caption that currently appears at the same time the slide displays,
but you want a slight delay, drag the caption so that its left edge aligns with 2s (a 2-second
delay) or 4s (a 4-second delay) in the header.
Tip: You can select multiple objects and move them at the same time. Hold down the SHIFT key and
click on objects to select consecutive stacked objects in the Timeline or to select non-consecutive
objects, hold down the Ctrl key and click on the objects to move.
Tip: You can adjust the zoom level of the Timeline easily. Click in the Timeline ruler and spin the
mouse wheel on your mouse to increase or decrease the zoom level. Alternatively, use keystrokes to
change the zoom level. Click on the ruler and then press Ctrl +[ to decrease zoom level, Ctrl + ] to
increase zoom level, or Ctrl + W to set the zoom level so all objects will fit within the current Timeline
width.

Changing object display order

Adobe Captivate lets you to add multiple objects, such as captions, highlight boxes, animations,
or images to slides. You specify the order in which objects appear. The Timeline lets you precisely
adjust the timing of all objects on a slide.
To change object order using the Timeline:
Open an Adobe Captivate project.
1.
Navigate to the slide that contains the objects whose order you want to change.
2.
If it is not open already, show the Timeline by clicking the splitter bar. To expand the Timeline,
3.
click the display arrow. You can also open the Timeline using View > Show Timeline or
Ctrl+Alt+T.
Change the order and timing of objects as required.
4.
For example, move the mouse over the left or right edge of an object on the Timeline until the
resize cursor appears, then drag the edge left or right. This will change when and for how long
the object appears.
If you have an object that currently appears at the same time the slide appears, but you want a
slight delay, move the mouse over the center of the object on the Timeline until the hand
appears; then drag the entire object so the left edge aligns with 2s (a 2-second delay) or 4s (a 4-
second delay) in the header.
184 Chapter 11: Adding and Managing Objects