GRASS VALLEY 8995UPC Datasheet

Key Features
• High-quality upconverter with
synchronizer for robust signal handling
• Image enhancement and pixel-level
motion adaptive conversion for superb
picture quality
• Full video proc. amp functions, including
RGB and component color controls, video
gain, chroma gain, phase control (hue),
Y/C White/Y Black clip controls, and color
space conversion (ITU 601, ITU 709)
• Minimum delay (1 frame conversion) for
low-latency live applications
• Maximum adjustable delay up to 9 frames
• Fiber-ready – accepts an optional SFP
fiber submodule providing optical inputs
or outputs
• Optional genlock reference input
submodule for reference timing that
supports loop-through, Tri-level sync and
color black
Specifications
Supported Frame Types
GeckoFlex with 8900NET (Net Card) for configuration
Power Rating
18 Watts – dual slot
Inputs
SD-SDI: One electrical or optional fiber optic
• Input equalization: up to 125m
• Auto-sensing: Yes
• Return loss: >15 dB, 5 to 270 MHz;
>15 dB typical, to 1.5 GHz
Optical: Single-mode (optional)
Outputs
HD-SDI: Four electrical and up to two additional
optional fiber optic
• Return loss: >15 dB, 5 to 270 MHz;
>15 dB typ., to 1.5 GHz
• Signal level: 800 mVp-p ±10%
• Rise/fall time (20-80%): 140 ps typ. for HD,
500 ps typ for SD
• Output jitter in frame sync mode, low jitter applied:
< 0.2 UI p-p HD > 100 kHz
< 1.0 UI p-p HD > 10 Hz
Optical: Single-mode (optional)
Electrical Length (delay)
Fixed delay mode: Nominal: 2 frames (±1 pixel)
User-adjustable range: 2 frames minus 5 lines to
3 frames minus 5 lines
Synchronizing mode (asynchronous input):
Minimum: 2 frames minus 5 lines
Maximum: 3 frames minus 5 lines
Fixed delay mode = in Minimum Delay Mode:
Nominal: 1 frame (±1 pixel)
User-adjustable range: 1 frame to 2 frames minus 5
lines
8995UPC Upconverter and Frame Sync
The 8995UPC is a compact, broadcast-quality
fiber-ready upconverter. Conversion is of the
highest quality, with pixel-adaptive motion
processing. In addition, the 8995UPC provides
the most robust signal handling with the low
hysteresis synchronizer, redundant reference,
and perfect-picture mode of the 8985FS.
The 8995UPC is fully featured with color-space
conversion and a powerful video proc. amp
that includes RGB color correction with gamma
and component with Y/C clip level adjustments.
Powerful embedded-audio handling includes
channel-level and Dolby E stream routing. PCM
audio processing eliminates the clicks caused
by the video synchronizer dropping or repeating
frames. This module silences the effects of hot
upstream video switching using a V-fade.
VITC and closed caption data conversion are
supported for same-frame-rate conversions,
making this an ideal module for playout
applications.
One of three types of optional SFP fiber optic
submodules can be installed in the fiber optic
rear cage connector to provide two fiber
inputs (Dual Receiver), two fiber outputs (Dual
Transmitter), or one fiber input and one fiber
output (Transceiver).
Refer to the rear module pinout and the block
diagram on the next page.
Synchronizing mode = in Minimum Delay Mode
(synchronous input): Nominal: 1 frame (±1 pixel)
User-adjustable range: 1 frame to 2 frames minus 5
lines
Additional adjustable delay: 0 to 6 additional frames
Conversion
Method: Motion adaptive
3:2/2:2 cadence: Automatic detection
Input: 480i @ 59.94 Hz
Output choices: 1080i @ 59.94 Hz, 1080p @ 23.98,
1080sf @ 23.98, or 720p @ 59.94 Hz
Input: 576i @ 50 Hz
Output choices: 1080i @ 50 Hz, 720p @ 50 Hz
Aspect Ratio Conversion
Conversion modes: 1:1, letterbox, pillarbox,
anamorphic, 14:9
Synchronization (Genlock)
:
• Standard frame bus genlock or external reference if
genlock submodule is installed (NOTE: at least one
module per frame must have genlock submodule)
• Adjustment: 0 to 1 frame in 1 SD pixel steps
Timecode and Closed Caption
VITC timecode and Closed Caption SD to HD
translation: same frame rate and output line select for
VITC and Closed Caption. NOTE: VITC and CC may not
work accurately in 23.98 Hz 3:2 pulldown from higher
frame rate conversion
Control And Monitoring
SNMP: Yes
Web page configuration: Yes
Local configuration: No
Newton support: Yes
NetConfig support: Yes
NetCentral support: Yes
Applications
• Where incoming feeds may be in either
480i or 576i SD video formats and require
upconversion to HD video
• For live production where low latency
conversion is required
• For conversion of signals with embedded
audio
Ordering Information
This module can be mounted in a GeckoFlex
frame but not in other 8900 series frames
including Gecko-A or Gecko-V frames. As this
module has no card-edge controls and in order
to configure this module an 8900NET (Net Card)
Network Interface module is required.
8995UPC
SD/HD video format upconverter, front module and dual
wide rear module set
8900GEN-SM
Genlock submodule. This submodule mounts to the
front module to provide reference input for the module
and frame reference bus. This is required for frame
synchronizing operation
SFP-13103G-M1TRX
Fiber transceiver. Low-power 1310 nm single-mode
optical transceiver submodule (one fiber input/one
fiber output)
SFP-13103G-M1DTX
Dual fiber transmitter. Dual low-power 1310 nm single-
mode optical transmitter submodule
SFP-13103G-M1DRX
Dual fiber receiver. Dual low-power 1310 nm single-
mode optical receiver submodule
For detailed specifications, installation and setup
instructions see:
www.grassvalley.com/docs/modular
57