24
8901 Utility Analog Video Distribution Amplifier
Key Features
•
Suitable for NTSC, PAL, SECAM, RGB, YUV,
Tri-level sync
•
Passive differential looping input with
eight active outputs
•
Selectable AC or DC input coupling modes
•
Card-edge adjustable gain control
•
Excellent differential gain and phase
specifications
•
Card-edge status indicators
Specifications
Supported Frame Types
GeckoFlex with 8900V-R GeckoFlex Video rear module,
Gecko video frames: 8900TX-V, 8900TF-V, 8900TFN-V
Power Rating
2.3 Watts – single slot
Input
Type: 1 Vp-p analog video with operation up to 2 Vp-p
NTSC, PAL, SECAM, RGB, YUV, Tri-level sync
Connector type: BNC
Impedance: Passive high impedance differential
loop-through
Return loss: >40 dB up to 5 MHz
CMRR: >66 dB 50/60 Hz
Common mode input: ±10V
Output
Voltage: 1 Vp-p ±2 dB
Number of outputs: Eight active plus one passive
loop-through input window out
Connector type: BNC
Impedance: 75Ω
Return loss: >40 dB up to 5 MHz
Output DC: <50 mV
This distribution amplifier is ideal for short
cable runs of high-quality signals. Its flat
frequency response and very impressive
signal-to-noise ratio ensures high-quality
copies to all eight outputs. The AC coupled
mode is used when the incoming video
signal has a blanking level at anything other
than zero volts. For handling color-difference
signals (B-Y, R-Y), DC input coupling is
recommended. Additionally, the 8901 module
can be used for simple fanout distribution of
AES/EBU 1 Vp-p coaxial digital audio signals
that do not need reclocking. The bandwidth of
the 8901 easily handles the 6 MHz frequency
response required by professional 48 kHz
AES/EBU digital audio signals. Our entire
line of both analog and digital distribution
amplifiers offer passive differential loop-
through inputs designed to remove common
mode hum induced by cable runs adjacent to
AC mains cables.
AC Coupled
Analog
DC Coupled
Video
Input
Performance
Frequency response:
• ±0.025 dB to 5 MHz
• ±0.05 dB 5 to 8 MHz
• –1 dB at 16 MHz
Differential gain: <0.1%
Differential phase: <0.1°
Gain range: ±2 dB
Tilt: <0.5%
Coupling: AC, DC
Electrical length: 20 ns
Temperature range: 0° to 30°C
Indicators/Controls
User controls: Output gain adjustment range: ±2 dB
LED indicators: Fault, power, frame bus
communication
8900V-R
J1
J2
J3
J4
Outputs
J5
J6
J7
J8
J9
J10
Loopthru
Gain
Ordering Information
This module can be mounted in a GeckoFlex
frame when ordered with the 8900V-R GeckoFlex
Video rear module.
8901
Utility analog video distribution amplifier
For detailed specifications, installation, and setup
instructions see:
www.grassvalley.com/docs/modular
Outputs
Input
Analog
Video
Outputs