Removing Glass Panel - Vexar CD32M (-1)(-2) Owner's Operation And Installation Manual

Direct-vent fireplace
Table of Contents

Advertisement

INSTALLATION
Continued

REMOVING GLASS PANEL

CAUTION: Before you proceed, make sure your
gas control valve is in the OFF position.
1.
To remove louvers, pull both spring latches (located in each
end of louver) toward center of appliance at the same time
until disengaged from locating holes. Repeat for bottom end
spring latches (see Figure 16).
2.
Remove screen rod by removing rod loop from glass door center
bracket. Slide screen rod either to the left or right of fireplace until
one end is free to completely remove screen from fireplace.
3.
Undo latches located on top and bottom of firebox (see Figure
17). Carefully swing door to the left. The glass door is se-
curely mounted to the firebox with 5 screws.
Glass
Bottom
Louver
Figure 16 - Removing Louvers
Figure 17 - Spring Latches
INSTALLING LOG SET
Each log is marked with a number in the following diagram. These
numbers will help in identifying the logs when installed. It is very
important to install these logs exactly as instructed. Do not modify
logs. Only use logs supplied with fireplace.
Models CD32M and CD36M-A Series
1.
Place log #1 (back log) on top of grate as shown in Figure 18.
Make sure notches in bottom of log fit over grate.
2.
Place log #2 (large front log) over pins on grate (see Figure 19).
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111916-01C
Locating
Holes
Spring
Latch
Open
Close
3. Place log #3 (c-shaped crossover log) onto rear and front logs
as shown in Figure 20. Make sure it is seated properly on the
smooth surface on front log and on the pin on back log.
4. Place log #4 (small round log) on pin on right side of front log
(see Figure 21).
5. Place log #5 (small front log) onto the front left part of grate
making sure notches fit over prongs of grate (see Figure 22).
6. Place log #6 onto two pins on left side of back and front logs
(see Figure 22).
Figure 18 - Installing Log #1,
Models CD32M/CD36M-A
Series
Figure 20 - Installing Log #3,
Models
CD32M/CD36M-A
Series
Figure 22 - Installing Logs #5 and #6, Models CD32M/CD36M-A
Series
INSTALLATION
Removing Glass Panel
Installin Log Set
Figure 19 - Installing Log #2,
Models CD32M/CD36M-A Series
Figure 21 - Installing Log #4,
Models
CD32M/CD36M-A
Series
9 9

Advertisement

Table of Contents
loading

Table of Contents