Burner Flame Adjustment - Vexar CD32M (-1)(-2) Owner's Operation And Installation Manual

Direct-vent fireplace

Hide thumbs

Table Of Contents

Table of Contents

INSTALLATION

Continued

Lava Rock and Ember Material

For all models, place lava rock along sides and front of firebox

bottom in areas that are visible. It is not necessary to use all

lava rock provided.

NOTICE: Do not put lava rock on or under burner.

Placing lava rock on burner could cause perfor-

mance problems.

Pull ember material apart into pieces no larger than a dime. Place

loosely and directly onto exposed section of front burner and

along space between burner and grate prongs. These will create

glowing ember appearance as flame touches ember material.

Do not block air slots by using too much ember material in one

area. It is not necessary to use all ember material provided.

When lava rock and ember material are in place, close and

latch glass door and secure louvers in place.

WARNING: The glass door must be securely in

place before operating fireplace. Do not operate fire-

place if glass is missing or broken.

DECORATIVE FACING

Any noncombustible material may be used as facing (glass, tile,

brick, etc.) as long as the proper clearances are observed (see

Clearances to Combustibles, page 3). Louvered openings must not

be obstructed and upper and lower panels must remain accessible

for service. Use only heat-resistant, noncombustible mortar or

adhesive when securing decorative facing materials.

FACE EXTENSION FOR MODEL CD32M ONLY

Model CD32M comes equipped with a front face extension. The

front face extension would add 3

height of the fireplace face.

To install face extension:

Remove existing screws from front face assembly as shown in

Figure 29.

2. Align holes on top face extension with holes on top side of

front face assembly and secure with screws previously removed

(see Figure 29).

3. Align holes on right face extension with holes on right side of

front face assembly and secure with screws previously removed

(see Figure 29). Do the same for left side.

4. Secure top face extension with left and right face extensions

with two sheet metal screws (see Figure 29).

For more information, visit www.desatech.com

111916-01C

" to the width and 3/4" to the

Installing Log Set (Cont.)

Face Extension for Model DC32M Only