Programming For Cam6.6 Use - Russound ST2-XM2 1 Manual

ST2-XM2 TUNER PROGRAMMING

PROGRAMMING FOR CAM6.6 USE

To Program the CAM6.6 (with no internal tuner) to operate with the ST2-XM2 Tuner:
(refer to the CAM6.6 Instruction Manual for details)
1. Enter the Setup Menu by pressing the Setup button on the side of the UNO-S1/S2 keypad.
2. PERIPH SETUP appears. Press the Next button to see SOURCE SETUP. Enter the Source Setup
Menu by pressing the Next button on the UNO-S1 keypad.
3. BASIC SETUP will appear. Enter the Basic Setup Menu by pressing the Next button again.
4. SOURCE NUM will appear. Use Volume Up and Volume Down buttons to select the source number
to which Tuner 1 (XM) is connected. Press the Power button to enter your choice.
5. SOURCE NAME will appear. Use Volume Up and Volume Down buttons to select the name for the
source (e.g., Tuner 1 or XM). Press the Power button to enter your choice.
6. COMMAND TYPE will appear. Select PERIPHERAL from the list. Press the Power button to enter
this choice.
7. SAVE CHANGES? appears. Select "Yes" and press the Power button to save changes.
8. SOURCE NUM appears again. Repeat steps 4 through 7 to configure the second tuner.
9. Press the Setup button three times to back out of the Installation Menu.
To Program the CAM6.6 (with internal tuner) to operate with the ST2-XM2 Tuner:
(refer to the CAM6.6 Instruction Manual for details)
When the CAM6.6 has an internal tuner installed in the Source 1 position, use sources 2 through 6
for the ST2-XM2.
Source Configuration Note:
When the ST2-XM2 Tuner is used with the CAM6.6 or other RNET controller, it is configured as an
RNET command type "Peripheral" and is connected via the RNET bus. This makes the tuner behave
as a fully integrated device with UNO keypad support. Each tuner must be set up with a unique
source number (1 - 6) or unassigned. An unassigned tuner is not controlled by the RNET bus.
Key Function Note:
When using the tuner with the CAM6.6 system, do not reassign keypad and remote buttons for tuner
control in the CAM6.6 Key Configuration Menu. When the tuner is assigned the "Peripheral" command
type in the CAM6.6 Setup Menu, key assignments and functions are automatically assigned and will
operate as shown in the preceding UNO-S2 keypad and SRC2 remote diagrams.
33