Src2 Remote Control With Rnet Controller - Russound ST2-XM2 1 Manual

SRC2 Remote Control Operation
Turning the unit on
The tuner is power managed by the CAV6.6 or
other RNET-enabled controller. If the tuner is in
standby mode, any button press of the SRC2
will bring the tuner out of standby mode when
used with the UNO keypad.
Selecting the desired tuner
To select a tuner, push
name/number associated with Tuner 1 (XM1) or
Tuner 2 (XM2), or use the numeric source inputs at
the bottom of the SRC2.
Selecting an XM Mode
Push , , or
operating modes.
Exiting an XM Mode
Press to exit XM operating mode menu.
Signal Strength mode
Press and hold and release. The display shows
the signal strength rating. To exit press
Selecting the desired channel
Use the Channel and
for manual tuning. To move quickly through the
channels, press and hold the button for more than
1.5 seconds. To directly select a channel, enter the
three- or four-digit channel number.

SRC2 REMOTE CONTROL WITH RNET CONTROLLER

and choose the source
to toggle between XM
.
or and
ST2-XM2 OPERATION
Selecting a Bank
To select a bank, press and hold
or for bank down.
Recalling a Memory Preset
Press and to scroll through a loop of
all the memory presets for the currently selected
bank. Only configured presets will be displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
for bank up
23