Table of Contents
Advertisement
UNO-S2 Keypad Operation
NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the controller's programming
steps.
Turning the unit on
The tuner is power managed by the RNET-
enabled controller. If the tuner is in standby
mode, any button press of the UNO-S2 keypad
will bring the tuner out of standby mode.
Selecting the desired tuner
On the UNO-S2 keypad, press
either Tuner 1 (XM1) or Tuner 2 (XM2) by choos-
ing the source name/number associated with
Tuner 1 or 2.
Selecting an XM Mode
Push
to toggle between XM modes.
Exiting an XM Mode
Press and release
until EXIT is displayed to
exit XM mode selection menu.
Selecting the desired channel
Use
and
for manual channel selection.
The channel will appear on the keypad and the
active tuner. To move quickly through the chan-
nels, press and hold either
than 1.5 seconds
.
UNO-S2 KEYPAD CONTROL WITH RNET CONTROLLER
to select
or
for more
ST2-XM2 OPERATION
Signal Strength Mode (XM)
To check XM signal strength, press and hold
then release. The display shows the signal
strength rating. To exit, press
Selecting a Bank
To select a bank, press and hold
up or
for bank down. The bank's name will
be temporarily displayed on the UNO-S2.
Recalling a Memory Preset
Press
and
to scroll through the memo-
ry presets for the selected bank. This procedure
will step through all of the presets in the current
bank, then loop back to start at the first one.
Only configured presets will be displayed.
Mute
Press
to mute/unmute the tuner audio output.
again.
for bank
21
Advertisement
Table of Contents
