ST2-XM2 Tuner Setup Menus
Note: The Setup Menu procedures must be performed from the ST2-XM2 Tuner front panel.
The ST2-XM2 Tuner Setup Menus provide setup and naming procedures for the ST2-XM2 main chas-
sis and the XM tuner modules. These procedures include source number assignments, assigning a
custom name to a memory preset or a bank, factory initialization and system information.
If the ST2-XM2 is used with a non-RNET system, the ST2-XM2 can be connected and operated with-
out any setup programming. Follow the setup menus if custom names are desired, or for system
info.
If the ST2-XM2 is used with an RNET system such as CAV6.6 or CAM6.6, the following minimum
setup must be performed for the ST2-XM2 to be properly controlled by the CAV6.6 and CAM6.6.
1. ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2. CAV6.6/CAM6.6 Source Setup Menu - Configure the source numbers assigned in step 1 for
Tuners 1 and 2, and assign command type PERIPHERAL.
NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to
the CAV6.6/CAM6.6 (must be powered on last) to establish a connection.
ST2 Chassis Setup Menu
Source Number (Chassis)
The Source Number procedure permits Tuner 1
(XM1) and Tuner 2 (XM2) to be assigned the
proper source numbers to be used in an RNET
system.
Note: The source number must be assigned as
PERIPHERAL in the RNET controllers.
Note: Each of the ST2-XM2 modules can be con-
figured as source number "unassigned" if the
module is used in another system (e.g., home
theater) or will not be used as a source in the
RNET system.
ST2-XM2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until SOURCE NUM appears on the tuner.
3. Press BAND. TUNER # appears.
4. Press the Tune Up/Down buttons to select the
Tuner # (Tuner 1 is XM1, Tuner 2 is XM2).
5. Press BAND. SOURCE NUM appears.
6. Press the Tune Up/Down buttons to scroll
through the source numbers 1-6.
7. Press BAND to select the source number.
8. Repeat the process for the next tuner.
9. Press TNR SEL to exit the Source Number
menu.
(continued)
25