Maintenance And Care; When You're Done - Bissell Steam&Sweep Pet User Manual

M
aintenance and care

When you're done

1. Make sure both power switches are
in the OFF (O)position. Unplug power
cord from outlet.
2. Carefully remove mop pad from
swivel head, as mop pad and lower
assembly will be hot.
3. Any water remaining in the water
tank should be emptied prior to
machine storage.
4. Mop pad can be machine washed in
warm water with mild detergent. For
best results, air dry.
5. Wrap power cord around quick
release cord wrap on side of Steam &
Sweep™ Pet.
6. Wipe all surfaces of Steam &
Sweep™ Pet with a soft cloth. Store
upright in a protected, dry area.
NOTE: If steam output is reduced,
the nozzle may be blocked. To
remedy, unplug the unit, remove
the swivel head from the lower
body and pour vinegar through
the center tube of the swivel
head "neck". Clear the nozzle
by inserting a paper clip into the
brass spray tip located in the
bottom of the lower body.
Replacing the water purification system
If you fill your Steam & Sweep™ pet
cleaner with normal tap water, it is
essential to check the filter and replace
it when it is no longer effective. Change
the filter when the bright green grains
turn blue. If the filter is not changed
at the appropriate time, calcium
deposits will accumulate on the heating
element, causing damage or reduced
performance.
To replace the filter, pull it up and
away from the Steam & Sweep™ pet.
Using distilled or demineralized
water will maximize the
performance of your filter.
To order a replacement filter, refer
to the replacement parts section on
page 10.
w w w . b i s s e l l . c o m
CAUTION:
Upright storage of the
Steam & Sweep™ Pet with
a wet mop pad may result
in the formation of white
marks on your floor. To
remove the white marks,
clean area with vinegar.
Tip:
Be sure to use only a BISSELL
water filter in your Steam &
Sweep™ Pet.
8 0 0 . 2 3 7 . 7 6 9 1
9