Bissell Steam&Sweep Pet User Manual page 7

O
perations
Getting ready
1. The mop pad may have already come
attached to the swivel head. If not, attach
mop pad to swivel head using the Velcro
strips.
2. Fill the water tank.
A. Remove the tank by lifting straight up
and away from the unit.
B. Unscrew the cap at the bottom of
the water tank and remove the insert
assembly.
C. Fill the water tank with water. For
best results, water should be at room
temperature.
d. Replace the insert assembly and cap,
tighten until snug.
E. Replace the water tank by lining up
the vertical guides and gently sliding it
back into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely, make sure both switches are
in the "OFF" position and plug it into a
120-volt grounded outlet as described on
the Important Safety Instructions page.
4. Turn power button on. The ready light will
illuminate when the Steam & Sweep™ Pet
is ready for use.
NOTE: Upon first use of the Steam
& Sweep™ pet or first use of a
new filter, the pump may make a
"knocking" sound while the filter
fills with water. This is normal
and should not last longer than 1
minute. Continue to depress the
trigger until the knocking subsides.
w w w . b i s s e l l . c o m
2A.
2B.
2E.
WARNING:
Steam & Sweep™ Pet
will not pick up crayons,
marbles, and other large
objects.
8 0 0 . 2 3 7 . 7 6 9 1
2d.
7