Before You Clean; Steam Cleaning Hard Floors - Bissell Steam&Sweep Pet User Manual

O
perations

Before you clean

The Steam & Sweep™ pet can be
used as a sweeper and a steam
mop at the same time. For best
results on pet hair, use the Steam
& Sweep™ pet's powerful sweeper
to clear the floor of pet hair prior
to mopping.
1. Turn the brush switch to the On ( I )
position to activate the brush.
2. To empty the dirt container, turn the
power off, gently tap the release
pedal on the swivel head. Lift unit
straight up leaving bin on floor and
empty into a trash can. The dirt con-
tainer may be warm to the touch.
3. Replace the dirt container by
pushing it back into the swivel head
until it snaps back into place.

Steam cleaning hard floors

Your Steam & Sweep™ pet is
designed to clean hard flooring such
as ceramic tile, vinyl, marble, stone
and sealed hard wood floors. Use
of your Steam & Sweep™ pet on
waxed or some unwaxed floors
may result in a diminished glossi-
ness. The Steam & Sweep™ pet
is not for use on unsealed wood
floors. For best results, test in an
inconspicuous area and check the
care instructions from your flooring
manufacturer.
1. When the ready light illuminates,
begin cleaning by slowly passing
over the surface while pressing the
steam on demand trigger to emit
steam as needed.
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) leave the
Steam & Sweep™ Pet over the area for
a minimum of 15 seconds, but no lon-
ger than 20 seconds. For larger areas,
overlap swivel head placement.
3. When the Steam & Sweep™ Pet
stops emitting steam, turn the unit
off. Simply remove the water tank,
refill, and continue cleaning.
8
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
1.
Brush Switch
Dirt Bin
2.
Release Pedal
WARNING:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
Tip:
The Steam & Sweep™ Pet may
be used as both a steam mop
and a sweeper at the same time.
Tip:
During first use, it may take
several seconds for the Steam &
Sweep™ Pet to begin steaming.
The water needs to flow through
the filter to the heater. This delay
will only occur during initial use
or when using a new filter.
Power Switch
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1