Wall Switch Installation; Optional Remote Control; Wiring Diagram - Desa VT32EN Series Owner's Operation And Installation Manual

FIREPLACE INSTALLATION
Continued

WALL SWItCH INStALLAtION

The installation of a wall switch allows you to activate the gas
control valve and turn the fireplace on and off. The wall switch is
to be connected to the incoming 120 volt regular household wir-
ing that supplies the electricity to the fireplace. Refer to wiring
diagram below.

OPtIONAL REMOtE CONtROL

INStALLAtION (MODEL WRC)
Note: If using optional wireless hand-held remote control, the wall
switch must be in the ON position to be operational. The remote
control then becomes the switching mechanism for fireplace op-
eration.
1. Open lower louver panel of firebox.
2. The WRC model receiver does not require a battery. The
receiver can be installed by first plugging the short extension
cord into the fireplace receptacle. Then plug the receiver unit
into the extension cord. Finally plug the ignition module plug
into the receiver unit (see Figure 46).
3. Activate the remote handset battery by removing the insulating
tab on the back of the handset (see Figure 47). The battery is
included pre-installed.
4. Once the battery is activated the unit is ready to use.
5. Close lower louver panel.
INCOMING MAIN
GAS SUPPLY
EV1
EV2
GAS LINE TO
BURNER


WIRING DIAGRAM

Pilot Burner
Pilot Gas
Line
24V AC
STEP DOWN
TRANSFORMER
120V AC
www.desatech.com
Fireplace
Receptacle
Extension Cord
Figure 46 - Installing the WRC Remote Receiver
Battery Cover
1 Volt Battery
Back of
Handset
Figure 47 - Installing Battery into Back of Handset
WALL SWITCH
(SUPPLIED)
ELECTRICAL RATING:
120v, 60Hz, 0.7A
OPTIONAL
REMOTE
CONTROL
Remote Control
Receiver
Ignition
Module Plug
Pull to Remove
Insulation Tab
BLACK
INCOMING
120V AC
WHITE
(FUSE BOX
GREEN
OR BREAKER)
108860-01D