Configure The Smb/Cifs Server - Dell DX6000 Deployment Manual

Dell DX Object Storage – File Gateway Deployment Guide
# vi /etc/krb5.conf
2. Edit the file as shown with your domain name information.
[libdefaults]
default_realm =
[realms]
XYZ.PROJECT.LOCAL
kdc
kdc
}

Configure the SMB/CIFS Server

1. Run the following command to open the /etc/resolv.conf file.
#vi /etc/resolv.conf
2. Set the CFS DNS server address to the authoritative DNS server for the Active Directory domain
as shown here:
domain xyz.domain.local
search xyz.domain.local other.dns.domain
nameserver
Where xyz.domain.local is the fully qualified DNS name for the Active Directory realm, the
address xxx.xxx.x.xx should be replaced with the correct IP address for the Active Directory
DNS server.
NOTE: The Network Time Protocol service on the CFS server should be configured using either
using the Microsoft Active Directory domain controller for the domain it will be joining, or
using the same time server it has been set up to use.
3. In the file /etc/samba/smb.conf, replace the workgroup name AD, the realm name, and the
netbios name (in upper case characters – each max 14 characters) that is appropriate for the
site:
[global]
workgroup = XYZ
realm = XYZ.PROJECT.LOCAL
netbios name = CIFSFS
XYZ.PROJECT.LOCAL
= {
= xxx.xxx.x.xx (AD DNS server; see Site Survey)
= w2k8r2.xyz.project.local
NEXT STEP: Configure the SMB/CIFS Server
BEFORE YOU BEGIN: Did you Edit the krb5 File?
xxx.xxx.x.xx
Page 52