Dell DX6000 Deployment Manual page 44

Dell DX Object Storage – File Gateway Deployment Guide
both files will be configured to keep up to 8 log files, rotating weekly or at a max file
size of 512 MB.
Syslog facility – If the syslog option was selected, enter the facility to log to. The
default value is local1. Configuration of a remote syslog host must be done in the
syslogd configuration file.
Log level – Enter the minimum level of log messages to record. The default value is info.
Each log level includes the following:
info – errors, warnings and information messages like system start up and stop
verbose – errors, warnings, and info messages plus high-level operational functions
debug – errors, warnings, info and verbose messages plus lower level operational
functions
trace – all possible log messages
CNS host – The location of the name space server for the name space you are configuring. The
default is localhost (127.0.0.1), which will configure a name space on the local server. Enter an
external IP address, if using a remote server separate from the CFS server for the name space.
You can also enter a 0.0.0.0 address, if the name space must be created locally but needs to
connect to CFS shares on both the local server and remote servers.
DX Storage: use Zeroconf – Specify whether Zeroconf should be used to discover the list of
nodes in the Dell DX Object Storage cluster.
To use Zeroconf, the CNS must be in the same subnet with Dell DX Object Storage. If the CNS
must be located on a remote subnet, its address must be capable of routing to the subnet that
houses Dell DX Object Storage, and its address must be specified.
If you select No, complete the following:
Cluster primary node address – IP address or hostname for a Dell DX Object Storage
node in the target cluster. The target cluster must be the same as the one configured
for all CFS mounts.
Primary node SCSP port – the port the Dell DX Object Storage node uses for SCSP
communications. The default is 80.
Cluster secondary node address – the IP address or hostname for a second Dell DX
Object Storage node in the target cluster for redundancy. The target cluster must be
the same as the one configured for all CFS mounts.
Secondary node SCSP port – the port of the secondary DX Object Storage node uses for
SCSP communications. The default is 80.
NOTE: Primary and secondary DX Object Storage node addresses should be managed
through the site DNS server. Sites that use Microsoft Active Directory should use the
DNS server that is authoritative for the AD zone that the CFS server will join.
Page 42