Bernina Serger 1150MDA Owner's Workbook page 104

Mastering
Sergers
Your
BERNINA
®
Two-Thread Rolled Hem
Fabric .................................................................................batiste, 4" x 6"
Notes
Needle ................................................................ 70/10 Sharp or Microtex
Thread ................................................. 2 cones lightweight serger thread
Presser Foot .............................................................................. standard
Stitch .................................................. 2-thread rolled edge (right needle)
Attach the Upper Looper Converter to the upper looper.
Note: This is an optional accessory for the 700D.
Following the instructions in your owner's manual, thread the serger
for a 2-thread flatlock stitch. Adjust settings as directed.
Pull the Stitch Selection lever towards you.
Adjust the stitch length to 1.75mm.
Set cutting width at 2mm (normal).
Place the fabric under the presser foot and serge along one 6" edge,
trimming about 1 / " from the raw edge.
8
Return stitch length and thread tension levers to normal.
Trim and mount the sample.
BERNINA
®
M Y S 6/2006 104
ASTERING OUR ERGERS
©2006 BERNINA ® of America, Inc.
®
Permission to copy and distribute in printed and electronic formats granted only to Authorized BERNINA Dealers