Installing A Hot-Swap Hard Disk Drive - IBM 71412RU User Manual

Release latch
To install an additional hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page v and "Handling static-sensitive
2. Press the blue release latch on the filler panel and pull the handle to the open
3. Press the orange release latch on the power-supply handle and pull the handle
4. Slide the power supply into the bay and fully close the locking handle.
5. Connect one end of the power cord for the new power supply into the ac
6. Make sure that the ac power LED on the power supply is lit, indicating that the

Installing a hot-swap hard disk drive

The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v The server supports up to four 1-inch (26 mm) slim-high, 2.5-inch, hot-swap hard
v For a list of supported optional devices for the server, see http://www.ibm.com/
v Inspect the drive tray for signs of damage.
v Make sure that the drive is correctly installed in the tray.
36
IBM System x3850 M2 and System x3950 M2 Types 7141 and 7233: User's Guide
AC power
LED (green)
DC power
LED (green)
Error LED
(amber)
Release latch
devices" on page 30.
position, then remove the filler panel from power-supply bay 2.
to the open position.
connector on the back of the power supply, and connect the other end of the
power cord into a properly grounded electrical outlet.
power supply is operating correctly. If the server is turned on, make sure that
the dc power LED on the top of the power supply is lit also.
disk drives in the standard hot-swap bays.
servers/eserver/serverproven/compat/us/.
Hot-swap
power supply
Power supply
filler