I/O-board connectors
The following illustration shows the connectors on the I/O board.
SATA signal
If you are installing a hypervisor key, install it in the internal USB connector.
I/O-board LEDs
The following illustration shows the LEDs on the I/O board.
RAID write
protect LED
SAS
heartbeat LED
SAS
backplane
signal
Remote
Supervisor
Adapter II
System
Management
access
Battery
Front USB
I/O card
fault LED
Remote Supervisor Adapter II
Internal USB
ServeRAID-MR10k
SATA power
SAS backplane power
Front panel/light path diagnostics
DVD
ServeRAID-MR10k
fault LED
Power LED (2x)
Attention LED (7x)
Chapter 2. Installing optional devices
Hot-plug switch card
PCI Express x8
(x8 lanes) slot 1
PCI Express x8
(x8 lanes) slot 2
PCI Express x8
(x8 lanes) slot 3
PCI Express x8
(x8 lanes) slot 4
PCI Express x8
(x8 lanes) slot 5
PCI Express x8
(x8 lanes) slot 6
PCI Express x8
(x8 lanes) slot 7
25