Related Manuals for TDK-Lambda GEN 150-22 ABCDE
Summarization of Contents
WARRANTY
Limitation of Warranty
Details warranty exclusions for improper usage, unauthorized modifications, and buyer's circuitry.
Warranty Service
Provides instructions for returning products for repair or warranty service.
SAFETY INSTRUCTIONS
Installation Category
Defines the product's evaluation to Installation Category II for transient overvoltage.
Grounding
Explains the importance of connecting the chassis to electrical ground for shock hazard prevention.
Live Circuits
Warns against removing covers and accessing internal components without disconnecting power.
1. GENERAL INFORMATION
Introduction
Describes the Genesys™ 3300W power supply series and its features.
Features and Options
Lists key features like active PFC, RS232/485 interface, parallel operation, etc.
2. SPECIFICATIONS
Output Rating
Details voltage, current, and power ratings for all models.
Input Characteristics
Specifies input voltage, current, power factor, and efficiency.
Constant Voltage Mode
Provides specifications for constant voltage operation.
Constant Current Mode
Provides specifications for constant current operation.
Protective Functions
Details foldback protection, over-voltage, and under-voltage limits.
Safety/EMC
Lists applicable safety standards and EMC compliance details.
3. INSTALLATION
Preparation for Use
Covers initial inspection, AC source connection, and basic setup.
AC Input Power Connection
Guides on connecting the power supply to the AC source.
Turn-On Checkout Procedure
Provides steps for verifying basic operation after initial power-up.
Connecting the Load
Details wiring considerations for connecting loads, including sense connections.
4. FRONT AND REAR PANEL CONTROLS AND CONNECTORS
Front Panel Controls and Indicators
Explains the functions of front panel controls, indicators, and displays.
Rear Panel Connections and Controls
Details the rear panel connectors and their functions.
Rear Panel SW1 Setup Switch
Describes the 9-position DIP-switch for configuration settings.
Rear Panel J1 Programming Connector
Details the J1 connector for analog programming and monitoring.
5. LOCAL OPERATION
Standard Operation
Explains Constant Voltage and Constant Current modes.
Over Voltage Protection (OVP)
Details setting and resetting the Over Voltage Protection.
Under Voltage Limit (UVL)
Details setting and resetting the Under Voltage Limit.
Series Operation
Describes connecting units in series for increased output voltage.
Parallel Operation
Explains basic and advanced methods for parallel connection.
6. REMOTE ANALOG PROGRAMMING
Local/Remote Analog Control
Explains selecting between local and remote analog control.
Remote Voltage Programming
Guides on programming output voltage and current via analog signals.
Resistive Programming
Details programming output voltage and current using external resistors.
7. RS232 & RS485 REMOTE CONTROL
Configuration
Covers default settings, address, baud rate, and RS232/RS485 selection.
Command Set Description
Details the commands for controlling and monitoring the power supply.
Status and Error Commands
Explains commands for reading status, error registers, and SRQs.
Serial Communication Test Set-Up
Provides instructions for testing serial communication operation.
8. ISOLATED ANALOG PROGRAMMING OPTION
Specifications
Details accuracy and coefficients for 0-5V/0-10V and 4-20mA options.
Setup and Operating Instructions
Guides on configuring for 0-5V/0-10V and 4-20mA isolated programming.
9. MAINTENANCE
Troubleshooting
Provides a guide to diagnose and resolve operational problems.
Fuse Rating
Lists internal fuse types and ratings for fault protection.
Need help?
Do you have a question about the GEN 150-22 ABCDE and is the answer not in the manual?
Questions and answers