How To Set The Time And Date - Honeywell Ademco 8132-i User Manual

How to Set the Time and Date

You can set the time and date from the Set Time & Date screen. This screen can
be accessed by pressing the Time and Date bar located at the bottom of each
Symphony/Symphony-i screen.
•
Since Synchronized with network clock is always selected on the Set Time
& Date screen, whenever Symphony/Symphony-i checks in with the server
(every 10 seconds) it will get the current GMT time. If the
Symphony/Symphony-i time differs from GMT by 10 seconds or more, the
Symphony/Symphony-i time will be reset. Additionally, Symphony/Symphony-i
will send time to the control panel every hour. This 1-hour timer starts on
Symphony/Symphony-i power-up.
•
Daylight Savings Time is processed internal to the Symphony/Symphony-i, since
Symphony/Symphony-i gets GMT from the server. When Symphony/Symphony-i
adjusts for DST, the next time the 1-hour timer expires, the new value should be
sent to the control panel.
IMPORTANT: This means that the Symphony/Symphony-i setting will override
and overwrite the control panel time setting. That is, if the control panel is set for
DST and adjusts but Symphony/Symphony-i is not, upon the 1-hour timer
expiration, the control panel will be updated to the current Symphony/Symphony-i
time that is not adjusted for DST.
Refer to the Time Zones Settings chart (on the following page) to select the
corresponding Time zone for the location of the Symphony/Symphony-i by pressing
the "increase" or "decrease" arrow buttons.
Adjust either or both the time and date by pressing the "increase" or "decrease"
arrow buttons as necessary until the proper month, day, year, hour, and minute are
displayed.
Symphony/Symphony-i Setup (Cont'd)
OK
BUTTON
Set Time & Date Screen
INCREASE
BUTTON
(TYPICAL)
DECREASE
BUTTON
(TYPICAL)
CANCEL
BUTTON
AUI-009-V1
63