Sony SRSD25 - SRS D25 2.1-CH PC Multimedia Speaker Sys Operating Instructions

A
Rear
3
1
4
2
5678
B
Right satellite Left satellite
speaker (rear) speaker (rear)
Subwoofer (rear)
Portable audio device, PC, etc.
To LINE OUT or
To wall outlet
headphones jack
If the TV picture or monitor display is
English
magnetically distorted
Although this system is magnetically shielded, there may be
Before operating the system, please read this manual thoroughly
cases that the picture on some TV sets/personal computer sets
and retain it for future reference.
may become magnetically distorted. In such a case, turn off the
WARNING power of the TV set/personal computer set once, and after 15 to
30 minutes turn it on again. For the personal computer set, take
the appropriate measures such as data storage before turning it
To reduce the risk of fire or electric shock, do not expose
off.
this apparatus to rain or moisture.
When there seems to be no improvement, locate the system
To reduce the risk of electrical shock, do not open the cabinet.
further away from the TV set/personal computer set.
Refer servicing to qualified personnel only.
Furthermore, be sure not to place objects in which magnets are
To reduce the risk of fire, do not cover the ventilation opening of
attached or used near the TV set/personal computer set, such
the apparatus with newspapers, tablecloths, curtains, etc.
as audio racks, TV stands, toys etc. These may cause magnetic
Do not place the naked flame sources such as lighted candles on
distortion to the picture due to their interaction with the system.
the apparatus.
To reduce the risk of fire or electric shock, do not expose this
Others
apparatus to dripping or splashing, and do not place objects
• If you have any questions or problems concerning this system
filled with liquids, such as vases, on the apparatus.
that are not covered in this manual, please consult your
Do not install the appliance in a confined space, such as a
nearest Sony dealer.
bookcase or built-in cabinet.
• Should any problem persist, consult your nearest Sony dealer.
As the main plug is used to disconnect the system from the
mains, connect the system to an easily accessible AC outlet.
Identifying parts
Should you notice an abnormality in the system, disconnect the
main plug from the AC outlet immediately.
The system is not disconnected from the mains as long as it is
1 Input cord
connected to the AC outlet, even if the system itself has been
Connecting cord with stereo-mini plug
turned off.
2 Power cord
Excessive sound pressure from earphones and headphones can
cause hearing loss. 3 Subwoofer
4 Satellite speaker (L)
CAUTION
5 Power indicator
You are cautioned that any changes or modification not expressly
6 POWER button
approved in this manual could void your authority to operate
7 i (headphones) jack
this equipment.
8 VOLUME control
NOTICE FOR THE CUSTOMERS IN THE USA
9 Satellite speaker (R)
These following indications are located on the bottom
exterior.
Hooking up the system
(See fig. B)
1
Connect the system to the source device.
2
Connect the AC power cord to the wall outlet.
This symbol is intended to alert the user to
When the system is connected to the monaural
the presence of uninsulated "dangerous
voltage" within the product's enclosure
jack of the source device
that may be of sufficient magnitude to
The sound may not come through the right speaker.
constitute a risk of electric shock to persons.
To connect to a stereo phone-type headphones
This symbol is intended to alert the user to
jack
the presence of important operating and
Use the optional plug adaptor* PC-234S or optional connecting
maintenance (servicing) instructions in the
cord RK-G138.
literature accompanying the appliance.
Important Safety Instructions
* The above optional accessories are not provided in some areas.
1) Read these instructions.
2) Keep these instructions.
9 Listening to the sound
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water. First, turn down the volume on this system. When connecting
6) Clean only with dry cloth. the system to the headphones output, turn down the volume of
7) Do not block any ventilation openings. the source device.
Install in accordance with the manufacturer's instructions.
1
Press the POWER button ( on).
8) Do not install near any heat sources such as radiators, heat
The Power indicator lights up.
registers, stoves, or other apparatus (including amplifiers)
2
that produce heat. Start playing on the source device.
9) Do not defeat the safety purpose of the polarized or
3
Adjust the volume.
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two Set the volume of the source device to moderate level, and
turn the VOLUME control on this system.
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided 4
Press the POWER button ( off) after using.
plug does not fit into your outlet, consult an electrician for
The Power indicator goes off.
replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
To use the headphones/earphones
particularly at plugs, convenience receptacles, and the point
Connect the headphones/earphones to the i (headphones) jack.
where they exit from the apparatus.
11) Only use attachments/accessories specified by the
Notes
manufacturer.
• If the source device has a bass boost function or
12) Use only with the cart, stand, tripod, bracket, or table
equalizer function, set them to off. If these functions are
specified by the manufacturer, or sold with the apparatus.
on, sound may be distorted.
When a cart is used, use caution when moving the cart/
• If the source device's headphones output has a line
apparatus combination to avoid injury from tip-over.
switch, better sound will be heard if it is set to on. See
the operating instructions of the source device.
Troubleshooting
Should you have a problem with your speaker system, check the
13) Unplug this apparatus during lightning storms or when
following list and take the suggested measures. If the problem
unused for long periods of time.
persists, consult your nearest Sony dealer.
14) Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any No sound
way, such as power-supply cord or plug is damaged, liquid
• Check that both this system and the source device are turned
has been spilled or objects have fallen into the apparatus, the
on.
apparatus has been exposed to rain or moisture, does not
• Turn up the volume of the system.
operate normally, or has been dropped.
• Turn up the volume of the source device as high as possible to
the extent that sound is not distorted. For details on volume
Precautions adjustment, refer to the operating instructions supplied with
the device.
On safety • Make sure all the connections have been correctly made.
The nameplate is located on the bottom exterior.
Low sound level
• Before operating the system, be sure that the operating voltage
• Turn up the volume of the source device as high as possible to
of the system is identical with that of your local power supply.
the extent that sound is not distorted. For details on volume
adjustment, refer to the operating instructions supplied with
Where purchased Operating voltage
the device.
U.S.A./Canada 120 V AC, 60 Hz
• Turn up the volume of the system.
European countries 220 – 230 V AC, 50 Hz
Distorted sound
Other countries • 120 V AC, 60 Hz
• Turn down the volume of the source device to the point
• 220 – 240 V AC, 50 Hz
where the sound is no longer distorted. For details on volume
adjustment, refer to the operating instructions supplied with
On operation the device.
• Should any solid object or liquid fall into the system, have the • If the source device has a bass boosts function, set it to off.
system checked by qualified personnel before operating it any • Turn down the volume of the system.
further.
There is hum or noise in the speaker output.
• Although this system is magnetically shielded, do not leave
• Make sure all the connections have been correctly made.
recorded tapes, watches, personal credit cards, or floppy disks
• Make sure none of the audio devices are positioned too close
with magnetic coding in front of the system for an extended
to the TV set.
period of time.
The brightness of the POWER indicator is
On placement
unstable.
• Do not set the system in an inclined position.
• The brightness of the Power indicator may become unstable
• Do not leave the system in a location near heat sources, or in a
when the volume is turned up. This is not malfunction.
place subject to direct sunlight, excessive dust, moisture, rain
or mechanical shock.
On cleaning
Do not use alcohol, benzine, or thinner to clean the cabinet.
Specifications
Speaker section
Satellite speaker
Speaker system 38 mm, Full range, magnetically
shielded
Enclosure type Bass reflex
Impedance 4 Ω
Cord length 1 m
Subwoofer
Speaker system 67 mm, Woofer
Enclosure type Bass reflex
Impedance 4 Ω
Amplifier section
Rated output 5 W + 5 W
(10% T.H.D., 1 kHz, 4 Ω)
(Satellite speaker)
15 W
(10% T.H.D., 100 Hz, 4 Ω)
(Subwoofer)
Input Connecting cord with
stereo mini plug (1 m, 39 / in.) × 1
3
8
(See fig. A)
Input impedance 7 kΩ (at 1 kHz)
Output Stereo mini jack × 1
(PHONES)
General
Dimensions (w/h/d) Approx. 65 × 65 × 67.5 mm
(2 / × 2 / × 2 / in.)
5 5 3
8 8 4
(Satellite speaker)
Approx. 208 × 118 × 130 mm
(8 / × 4 / × 5 / in.)
1 3 1
4 4 8
(Subwoofer)
Mass Approx. 90 g (3 oz.)
(Satellite speaker),
Approx. 2 kg (4 lb. 7 oz.) (Subwoofer)
Cord length 1.8 m (Power cord)
Power consumption 24 W
Supplied accessories
Operating Instructions (1)
Optional accessories
Connecting cord RK-G138
Plug adaptor PC-234S
The above optional accessories are not provided in some areas.
Design and specifications are subject to change without notice.
This warranty is valid only in the United States.
Cette garantie ne s'applique qu'aux États-Unis.
Esta garantía sólo es válida en Estados Unidos.