Konica Minolta MS7000 MK II User Manual page 39

3
After turning the power to the system OFF and unplugging its power cord from the
electrical outlet, contact your Technical Representative, being sure to provide him or her
with the currently displayed code (Above code).
G Other Malfunctions
Display
3-13
Code Description
The power to the printer is off or there is a prob-
lem with the connection of the interface cable to
the printer. Turn on the printer or make sure that
the interface cable is securely
connected.
The upper cover of the printer is not closed.
Make sure that it is completely closed.
Paper Empty Indicator
Lights up when the Printer is not loaded with the
paper size selected for use, or when either the
Paper Feeding Tray or Paper Cassette has run
out of paper with Auto (auto paper selection) se-
lected.
The Scanner is connected to the PC and ready
for scanning by pressing the Start Key.
This display is blinking when the Scanner
is in operation.
The Scanner is not connected to the PC. Turn
ON the PC or connect the Scanner to the PC
with the interface cable.
The Lens is not mounted or is loose.
Check the Lens for correct installation and rein-
stall it as necessary.
The Projection Lamp is burned out.
Replace the lamp.
*If the lamp goes out during a print cycle, a
blank print may be output.
Magnification warning display
Did the modification of the magnification by an
electronic zoom.
Lights up when setting besides the standard
magnification.
Scanner