Prepare The Remote Control - Philips DS9800W/37 User Manual

Connect power to standalone
docking charger (optional)
ON/OFF
• To charge your iPod/iPhone/iPad, connect
the AC power cord to
• the ~ DC IN socket on the docking
charger.
• the wall power socket.
Switch to standby
The unit switches on automatically after power
connection.
• To switch the unit to standby mode, press
on the back of the main speaker.
• To switch the unit on from the standby
mode, press again.

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
For first-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
EN 13