Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine, or fire. Never discard batteries in fire.
•
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
•
The battery contains chemical substances, so it should
be disposed of properly.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
For first-time use:
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
Turn on
In standby mode, Press
main speaker.
» The
indicator turns amber.
» The unit switches to the last selected source.
Switch to standby mode
The unit switches to standby mode, when:
•
In power on mode, press
the main speaker.
•
In DOCK mode: no iPod/iPhone
connected over 15 minutes.
•
In USB mode: no PC-USB connected over
15 minutes.
•
In MP3 link mode: no audio device
connected over 15 minutes.
» The power indicator turns off.
on the back of the
on the back of
EN
11