Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 1 AAA battery with correct polarity
(+/-) as indicated.
3
Close the battery compartment.
Note
•
If you are not going to use the remote control for a
long time, remove the battery.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
Note
•
You can set the clock in standby mode only.
1
In standby mode, press and hold CLOCK
to activate the clock setting mode.
2
Press PRESET/ALBUM
/
to select 12
hour or 24 hour format.
3
Press CLOCK to confirm.
» The hour digits begin to blink.
4
Press PRESET/ALBUM
/
to set the
hour.
5
Press CLOCK to confirm.
» The minute digits begin to blink.
6
Press PRESET/ALBUM
/
to set the
minute.
7
Press CLOCK to confirm.
Note
•
You can also press VOL -/+ on remote control or main
unit to set hour format/hour/minute.
•
To exit clock setting mode without storing, press
/MENU.
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
You can press CLOCK to view the clock in any source
mode.
EN
Page 9