ROSE DISPLAYS ANOQUICK SQUARE WITH GOTCHA AND MULTICLIPS Manual

TM
AnoQuick

Parts

Instructions for Hanging

Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1
Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder.

Step 2

Slide the Gotcha Holder into the AnoQuick
Holder. Fig. 2

Step 3

Install the MultiClips in top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on the other round end and
push MultiClip into holder. Insert second
MultiClip. Fig. 3 & 4

Step 4

Push end caps into place. Fig. 4
Note: To remove Gotcha (and sign), simply rotate
end cap up out of the way.

Step 5

Suspend poster.

Important note:

Please save and reuse the AnoQuick Holder,
Gotcha Holder, End Caps and MultiClips for future
projects.
The AnoQuick TM is a trademark and Gotcha
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoQuickSQGotchaMC
Incept-9.9.02
with Gotcha
AnoQuick
Square Profile Gotcha
12A300SQ
® is a registered trademark of
®
Insert
Instruction Sheet
® Special
(no clip rail)
Figure 1
Figure 4
MultiClip
Square End Cap
1UP-0100
Figure 3
Figure 5
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
06-5545
Figure 2