ROSE DISPLAYS ANOQUICK SQUARE WITH CABLE CLIP AND BALL CHAIN Manual

AnoQuick™
Parts
Note: Use only
with graphics
mounted on 3/16"
foamboard or other
similar thickness.
Can also use a
folded edge thinner
substrate.
Instructions For Hanging
Step 1
Prepare edges of graphic. Place the graphic on
tabletop with one edge at the table edge. Using the
AnoQuick holder, run it across the graphic edge,
crushing it slightly. Fig. 1
Step 2
Starting at one corner, push the holder onto the
graphic. Work your way down the holder tapping
it down firmly to seat the graphic fully. Fig. 2
Step 3
Insert single ball of ball chain into inner channel
of Cable Clip. The cable should snap into place.
Fig. 3
Step 4
Align one round end of cable clip with top chan-
nel of the aluminum rail and insert. Once in
place, insert end of ball chain into channel. Then
press down on the other round end of the cable
clip and slide into rail by pushing on the clip.
Fig. 4
Note: Be sure to slide the ball chain into place by
pushing on the cable clip. Do not pull on, or
push against, the ball chain as this will cause it to
bind in the channel.
Step 5
Push end caps into place. Fig. 5
Step 6
Suspend poster. Fig. 6
The AnoQuick is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoQuickSQCableClipBallChain
Incept-7.4.02
Square Profile Instruction Sheet
AnoQuick Cable Clips
12A300SQ
End Caps
06-5050 06-5545
Figure 1
Figure 3
Figure 5
Ball Chains
96-0302P
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com