Specifications - Classe Audio CA-5200 Owner's Manual

28

Specifications

All specifi cations are accurate at the time of printing. Classé reserves the right to
adjust specifi cations without notice.
Power output
(both channels driven)
Frequency response
Phase
Signal-to-noise ratio
Channel separation
Noise floor (FFT)
Distortion (THD + noise)
Voltage gain
Sensitivity
Input Impedance
Rated power consumption (as per IEC60065 para. 2.3.10)
Idle power consumption
Mains voltage
Dimensions (not incl. controls or connectors)
Shipping weight
Net weight
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX +1 (514) 636-1428
Internet: http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.
200W/ch continuous rms @ 8Ω
370W/ch continuous rms @ 4Ω
10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
(ref. full ouput, 10Hz – 80kHz)
(unweighted, 1.0Vrms/1kHz input, 10Hz – 500kHz)
1.4Vrms for rated output @ 8Ω
(cannot be changed by dealer or user).
better than -10° @ 22kHz
108dB
better than 80dB @ 20kHz
all peaks less than -95dBV
(10Hz – 80kHz)
0.003% @ 8Ω
29.1dB
100kΩ
1056W
348W
specifi ed on rear panel
Width: 17.5" (445mm)
Height: 8.75" (222mm)
Depth: 21" (534mm)
133 lbs (60kg)
121 lbs (55kg)