How To Feed With The Bypass Mode - Canon 0080B002 User Manual

IMPORTANT
• If the paper feed operation stops due to a system error or a paper jam while
the scanner is scanning, resolve the problem, make sure that the scanned
image of the last page that was fed has been stored, and then resume the
scanning operation.
• Note that documents that are printed on thin paper may fall out of the
document eject tray.
• After you finish scanning, close the document feed tray and the document
eject tray extension to prevent damage to the scanner while it is not being
used.

How to Feed with the Bypass Mode

1.
Move the feed selection lever to the nonseparated document (
Feed Selection Lever
2.
Place the document into the document feed tray one sheet at a time, so that it
touches the stoppers, and adjust the position of the document guides.
3.
Start scanning from the application.
28
Using the Scanner
) side.