Table of Contents
Advertisement
Available languages
Available languages
1.
Use a V2" (12.70 mm) socket wrench to adjust the leveling
bolts. Turn the leveling bolts to the right to raise or to the left
to lower the refrigerator. It may take several turns to adjust
the tilt of the refrigerator.
NOTE: Do not unscrew the leveling bolts too much when
lowering the refrigerator. The bolt head will start to come
away from the refrigerator when in the lowest position. If the
screw does come out of the rear bracket, the compartment
access cover on the back of the refrigerator will have to be
removed to reinstall the bolt.
2. Adjust the front leveling bolts to bring the refrigerator top
parallel with the cabinet above the refrigerator.
•
For standard cabinets, leave approximately
Vs" (3.18 mm)
gap between the refrigerator's top hinges and the
cabinets.
•
For full-overlay cabinets, leave V4" (6.35 ram) gap
between the refrigerator's top hinges and the cabinets.
•
If you do not have a cabinet above the refrigerator, simply
adjust the refrigerator to make it level.
g
......................F
--
II
A. Top hinges
B. Front of the refrigerator
3. Adjust the rear leveling bolt to bring the refrigerator level with
the side cabinets or cabinet end panels.
4.
If you want, you may now use the four leveling bolts to raise
the refrigerator to reduce the gap between the refrigerator top
hinge and the cabinet opening. Check that all four leveling
legs still touch the floor and that the cabinet doors above the
refrigerator open all the way.
Replace Base Grille
1. Open the refrigerator doors to 96 °.
2.
Replace the base grille. Place the lower clips into the bottom
of the refrigerator and roll the grille up until it snaps into place.
TOOLS NEEDED: 5/_6"or adjustable wrench.
IMPORTANT: Models are preset with a quarter's-thickness
difference in door height and may not need adjusting.
If necessary after the refrigerator is loaded with food, follow the
steps below to adjust the door height up or down.
1.
2J
3.
Locate the height adjustment
bolt on the bottom hinge of the
refrigerator door.
NOTE: For easier access to the height adjustment
bolt, the
refrigerator door should be closed.
Turn the height adjustment bolt using the s/16"or adjustable
wrench.
•
To raise the height, turn the bolt to the right.
•
To lower the height, turn the bolt to the left.
Check to make sure the doors are even at the top and
bottom. If necessary, continue to turn the height adjustment
bolt.
1. Turn water supply line valve to "Open" position.
2. Turn refrigerator switch to ON position. Wait a few minutes.
Check water line connections for leaks.
3. Set refrigerator and freezer compartment
controls to the
midpoint setting. Check that the compressor is operating
properly and that all lights are working.
4.
Flush water system before using. See "Prepare the Water
System."
NOTE: If construction
will continue after refrigerator has been
installed, set controls to OFR
If refrigerator
does not operate
•
Check that the circuit breaker is not tripped or household
fuse blown.
•
Check that the power supply cord is plugged into the outlet.
•
See "Troubleshooting"
in the Use & Care Guide.
8
Advertisement
Table of Contents
